Hello,
I am having difficulty running my MTH engines through my Ross Custom Switches.
I have a pair of left hand switches, O-72s, connected together giving access to an inner loop run, and then another pair of right hand switches connected together, returning/connecting the inner loop run back to the outer loop.
The problem is my engines stop and turn off when they are running between 5-10 smph right in the middle of the connecting arms of the switches.
When I tilt up the engines, both rollers are on the center(power)rail.
The rails have been cleaned and the volt meter reads 19 in most spots.
I say most because sometimes, I may have a 0 reading in a small area, and that is between the engine’s rollers.
I am looking for help and suggestions.
Thank you all in advance and look forward to your insight.
Rich
