Skip to main content

Reply to "Ross Double Crossover and Dz1008 Shorting Issue"

You have 4 isolated black rails that surround the diamond. You have a white wire soldered to one of them. When going through the x overs in either direction. 2 rails should connect to the outside rails and 2 to the center rail. With the length of the diamond that little bit of powered rail is needed on some engines or cars as well as an outside rail connection.
Your best bet is to check with a meter for continuity. The rail should go to the relays common. Depending on switch position each rail will change from a center or to an outside rail.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×