Skip to main content

Reply to "Running Lionel command in DCS environment"

The engine is a used engine from what you posted. It may have a different ID than 1, so you may need to reprogram to get it to respond to your inputs.  All new engines come with an ID of 1, but if it's been changed, you may not know it's ID, which is needed for control inputs to select the loco.  I suspect this happens to a lot of folks with used engines where the owner has changed the ID to the last two digits of the loco road number or something similar.  It's possible you are not following the reprogramming instructions exactly.  Close isn't good enough .

Last edited by Landsteiner

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×