Skip to main content

Reply to "ScaleCraft early and later drives"

I thought you were only missing a side rod.  That was easy.  I will check for main rod, but I am quite sure no crossheads around here - I had to make the last set (not difficult; it is a plate soldered to a dowel).  Valve gear rods are even easier - all you need is .032 brass, a new file, and a vice.  A #63 drill is the first step, then you just trim 'till it looks right.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×