Doing this from Memory at work!
Start, with the two motherboard jacks next to the PWM label cojack provide on his prints. The jack closet to the outside of the board.
Red, to Roller. But, this might go into a bundle where other wires connect. I know one of these is to the DCDR etc. But, if the wiring is intact. You should have a connection from the red to the roller ohmmeter.
Black Wire will Go to DCDR.
SO, I BELEIVE THIS IS YOUR MAIN TRACK POWER IN. So, Keep this wire in and disconnect the other two below. I assume you should have lighting. When power is turned on. Then turnoff power connect AC regulator connector - Short? This is most likely your issue.
If not proceed to third connector....which, you should try on it own. Even, if you detect a short on the AC reg.
This was typed from my phone from memory. But, I think I'm right. One of the other guys here can straighten my five second response.
Gunrunner will understand my mess.
***** it appears in one of the pictures. He may have swapped the two wire connectors on the pair that are closet to each other.
Without, know the mother board. I would confirm. If he absolutely remembers where they go. Or, go by my guide.
shawn
-----------------------------------------------------------------------------------------------------------------------------------------
Second Connector - next to the one on outer edge of board.
Red - To AC Regulator board
Black to a Ac regulator board.
--------------------------------------------------------------------------------------------------------------------------------------------------
Two pin connector stand Alone.
Both of these go off to the smoke Unit
===================================================================================
****** it also appears from his pictures. He may have swapped both of the wires on the two pin connectors that are close to each other. If that bundle is going back to the roller. That connector should be on the pins closet to the edge of the board.
