rtr12 posted:1. The MTH signals have a separate harness for each signal and power that plugs into the controller. The signals themselves have their own, much smaller wires coming out of them. I should have included this picture in the above post.
I'm confused. If the MTH signal heads have 4 bare wires as shown in your photo, is the end-user expected to make 4 connections to the cable with plug for use with their controller? In your case, since your PCB has screw-terminals to go to the wehonest signal heads, then why do you need to track down that MTH connector? Can't you just take the 4 bare-wires from the MTH signal head and attach them to the screw-terminals on your PCB?
