Skip to main content

Reply to "Slow 8305 Engine"

jim sutter posted:

IMG_1007IMG_1008

Hope this helps you. To remove the cover you asked about, I believe its held in place by two small screws.

This helps a lot but alas I do not have the screws. Mine are aluminum tubes rounded at ends to hold on the cover. Well, here goes experimentations. Any advice in drilling out the tubes to get the one rounded edge off. What would be the best screw to use?  All of these two motors must be pre diagram. Thanks Jim!

60 year old child with problems

 

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×