Parts List :
Brass Strip : K&S #8230 .016 x 1/4 (.41mm x 6.35mm) Strip (2 pieces - top & bottom slide)
Down Rod & Linkage : K&S #8160 .032 (.81mm) Rod
Crossbar : K&S #8125 1/16 x.014 (1.57mm) Tube
Crossbar Swivel : K&S # 8126 3/32 x.014 (2.38mm) Tube
Linkage Stoppers : 1.6mm (2 - solder the one for the down rod, servo arm is free spinning)
Resistor : 220 Ω 1/8W (Current Limiter For LED)
Thread Lock : Locktite Blue 242
3 Pin Horizontal Male Header P=2.54mm (connection to controller)
5 Pin Vertical Male Header P=2.54mm (connection to Servo & LED)
3mm Flashing LED (Red)
(conductive) Adhesive Copper Foil
Wire
PCB (Gerber File attached)
Small piece of hardwood (for mounting block)
Dowel Rod (connection between mounting block & layout, think I used a Bamboo BBQ Skewer)
Also attaching one extra picture and since I couldn't find a Gerber repository (must have been thinking of the 3D repository), I'm attaching the Gerber here.
bd