I don't own one, this is a "general statement". Two wires must connect to that motors tabs. Are any other wires broken and hanging? No? Process of elimination says more than likely that is its placement(99%+). Can you read the voltage off the two wires? A low amp/watt test lamp/bulb? Soldering on a can motor is a difficult job sometimes. Melting plastic too badly and/or loosing contact inside the motor isn't always hard. The tabs for soldering on some can motors pull out/ push in and tab-lock in place. On can motors I use high heat and work very fast. A heat sink is always a good idea. Good luck.
|