Skip to main content

Reply to "Smoke unit replacement"

Well, you do have to wire the smoke heater to pins 5-6 of the R2LC, that output is no in the picture or your description.  Also, note that the 5W resistor has to be "cracked" to expose the internal wirewound resistor, you won't fit that big square block into the smoke unit.

This is the exact resistor I "crack" for 20 ohm smoke resistors: Yageo SQP500JB-20R, and if you want 27 ohm smoke resistors, use this one: Yageo SQP500JB-27R

I just put them diagonally in the vise and squeeze enough to crack the ceramic, it drops away and you have your smoke resistor.  At the rate I go through them, it saves quite a bit of money.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×