Stan it has taken awhile to get this done but finally we are getting there.
Sidings are connected and working fine.
Yesterday we started on turnouts and have one connected. It is working fine except changing the turnout requires two actions per relay, one to turn on the relay, then another to turn it off
Turn on relay one, turnout moves
Turn off relay one
Turn on relay two, turnout reverses
Turn off before can move in the other direction.
I note that the drawing says, "set module to interlock mode" and our guess is that when the two relays are interlocked, it is no longer necessary to turn off the first relay.; it is done automatically.
But we have not a clue how to set the interlock mode nor do we know if our guess is correct.
What do we do to switch the turnout with one push of the controller?
Thanks for your help. We may not be there yet but we know a lot more than we did earlier and are learning.
Bill
\