Skip to main content

Reply to "Starting new layout with Atlas track"

ibew701 posted:

Kris

I use a 40W soldering iron on Atlas track.  I rough up the surface to be soldered and then put a little solder on the side of the rail.  I use stranded wire that is pre-tinned and then just enough heat to melt the wire to the rail.  Takes 5 seconds, if the iron is hot.

Jim

Above is sound advice and very DCS friendly. The 5 seconds also will not melt nearby ties. Pretinned and a little flux paste on the freshly scraped rail..5 seconds or less. No srews,no drilling!

Last edited by willygee

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×