Skip to main content

Reply to "Steam with electrocouplers both ends"

Bob posted:
You might be able to use these methods on a diecast locomotive, but you'd need to check the pilot trucks to see if an electrocoupler could be mounted and the diecast Dremel work would be more difficult than on soft thin brass.

I've done a lot of chopping on diecast with the Dremel, I have a couple sets of Carbide bits that make short work of diecast.  Biggest issue is making sure you don't take too much.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×