Norton posted:When I cut my wood "die" I make the radius slightly larger than the finished radius of the cab roof as it will spring back slightly. That would have gotten rid of the slight droop on the firemans corner. Again, using heat will reduce the time to complete this to about 15-20 minutes vs days.
Pete
I have a 773 that I purchased recently and it at one point took a dive. The engineer's side's corner is good, but from about the middle over to that side, it sits a bit lower. How would I correct this? Would I use @Norton 's version to make the radius slightly larger? Dumb question, but how would that work without affecting the good side??
Thanks!