Skip to main content

Reply to "Subway track spark simulation"

Originally Posted by stan2004:
Now that the inventor has confirmed how he did it, I was inspired to experiment with this special-effect even though I don't run subways!

 

I don't have the short track sections he used so after initially trying to cut an outer rail with a hacksaw, I gave up and used a bandsaw to cut from the edge to make two outer-rail isolated islands - I figure some putty and gray paint could touch up the bed if need be.  3mm cool-white LEDs are installed from the bottom through 1/8" holes.  With a diode attached to center-rail and 1 resistor per LED taking track power as previously diagrammed, here's a short video with a streetcar which is closest thing I have to a subway.

 

 

spark-fun-bottom

 

What does the value of the resistor have to be for the LED? idk what amount to get or how to figure out the right resistor

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×