So, need some suggestions on lighting pcb install in a sd70ace. i’ve seen these installed in many ways on factory examples. The following pictures are of a sample cab and a lighting board pulled from another engine as a sample. This board has shrink tubing over part of the number board lights.
I have foil tape available for heat protection from the grain of wheat bulbs. Anyone, have a clear and clean way to install?
Should , I use heat shrink over the grain of wheat bulbs for the number boards lights on the new pcb? I’ve seen the lights without the shrink in some samples installations.
I know to use the heat shield tape. I’ve also seen double sided tape used to hold the number board lights in place.
shawn
