Skip to main content

Reply to "Suggestions on lighting board install"

I'm still trying to decide how to do this installation. My first run heat was definitely going to be a issue. I really wondering if putting a bit of shrink the new board bulbs would help. Also, have the issue of light shining down through the wind shield...

I need to find out if the number board lighting is run right off of track power on these ss 70's Maybe , the led route is the easy to go...what tends to be a good limiting resistor value. A diode perhaps in the case of going directly to track voltage.?

 

 

Last edited by shawn

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×