Skip to main content

Reply to "Sunset Models AT&SF 3746 lopsided drivers"

You could probably put anything in there as long as the heights match. Brass or even styrene rod would work. I have a few 3rd Rails where the front drivers have solid spring substitutes. Be sure to look in the packaging for a baggie of spares.

Most of these engines have a long screw through the steam chest and two screws under the cab opening. The steam chest screw is between the cylinders accessible from below. The cab screws will be looking right at you if you are looking into the cab, sometimes hidden by the deck plate if it has one.

If it is still binding up, I’d check the driver quartering. You can isolate the driver sets by pulling the rods. You will probably need a 3mm socket. You’ll actually see the rods at odd angles if you rotate the driveline manually.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×