Skip to main content

Reply to "Super-Chuffer Rev. 2"

GRJ,

I'm progressing through a Super Chuffer upgrade of my N&W Class A (28052).  I'm ready to tie into the chuff switch, but I want to make sure I'm using "best practice".  Should I tie the Pin 5 chuff input into the wire that connects the chuff switch to the existing main board (the chuff switch would "Y" - one wire to the main board and one to the Super Chuffer)?  Or, should I use chuff repeater on the Super Chuffer to run back to the chuff input on the main board?  I'm using an ERR Cruise Commander "M" (I don't think it matters), but was wondering if the Railsounds needed a separate chuff signal.

Thank you!

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×