Rich, I have used this gateman successfully for many years on my layout using an insolated rail. To make the man wave his flag it requires that one of the outside rails be removed and cut into 3 sections or pieces, 1 about 2" or as long as the contactor plate on the 1045C. Re-assemble the pieces using insolating pins. If you you do this between the ties you will not need insolating pins on the ends of your section and no extra insolating paper or tape on the ties. You will need to attach a track clip or solder a wire to the insulated 2" piece of rail to complete the circuit, then wire in the flagman as usual. Remember that the circuit will be grounded through the opposite side of the section you cut. You can do this on straight or curved track and eliminate the 1045C and the bumps. Have fun!!
|
|
