Forgive me if this is a common question, but I searched and could not find an answer.
I have the simplest setup, just trying to use a Sensor Track with Power Adapter, no LCS Wi-Fi or other more advanced hookups yet.
I hooked up the sensor track and power supply as instructions state(with cable hooked to Legacy base as well, of course).
When powering up, the red record light maybe flickers very briefly, and the green program light is on continuously. The green light eventually cycles (maybe 10-15 seconds after power is applied), then stays on continuously.
When I try to do the first thing regarding holding the program button down to program the track with an accessory number, the green light never flashes as the manual states it should. So I am stuck at the very beginning after the hookup of the cables here.
I tried both PDI connections under the sensor track, I get the same behavior with both.
Any thoughts? I am suspecting I got a bad Sensor track, but figured I would ask here before getting another one to play with and/or exchanging this one.
Thanks.
-Dave
