Skip to main content

TIU Channel not sending signal

I think I have a bad channel on my TIU. I've been running it for about 7 yrs.  My layout. 2 loops, ZW-L for power and a TIU Rev.L.  Power to the Loops are via Fixed 1 and 2.  I've had no problem running either Lionel or MTH engines on the tracks, even with both on the same loop. Last weekend I put an MTH engine on the track and it only ran in conventional mode on Track 4 powered through Fixed1.  But on the loop powered through Fixed2,  it would wait after power up for a command. So, it was receiving a DCS signal after track power up.  Same result. The track connected to Fixed2 passed the DCS signal, the other, nada.   I used the Remote to turn each chanel on an off in the System menu. Same result.  Am I correct in concluding Fixed 1 is Kaput?  Can I fix it?

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×