Reply to "tiu power questions, wall watts, brick voltage"

@GGG posted:

As long as barrel exact size you need only about 1.5A for the TIU.  So it would work.  Are you talking bricks for Aux power or Track power.  21 is fine for MTH, too much for Lionel.  G

thanks GGG.  I will check the power rating on that wall wart this evening. 

As to the 21 volt bricks, I was planning on using them for track power, if I used them at all.  Since I routinely mix up what is on my two loops, I usually wire them into the variable in side and then use the track setting in the remote to scroll the voltage up and down.  I have never been all the way to full voltage this way, though the post war Lionel stuff certainly takes more power to move.  I will also occasionely run a lionchief engine, again just scrolling up the voltage.  

I have however recently acquired a Z-4000.  I have not yet had to to research the best way to use it with the TIU.