Skip to main content

Reply to "TIU problem--is there a reset?"

Bob Shaw posted:

I have had the DCS signal generator on one of my output channels fail. Try connecting track power to a different output channel. Make sure the channel is in the " fixed" mode. Each TIU channel can be programmed using your remote.

Also make sure the DCS signal is turned on for each channel. Look at the DCS set up section in the manual. Resetting the TIU will turn them on or you can do it manually.

Was there any problem right before this happened like a derail?

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×