The problem developed when we were running two Legacy engines at once on a Legacy system. One engine suddenly stopped and refused to move forward. I followed the recommendations posed here. The suggestions were checking to see if a rubber tire had come off and none had, and to do a complete reprogramming of the locomotive. Programming didn't change anything. A further test was conducted on another Legacy locomotive and it performed per manual. I disconnected the Legacy line to the track and tried running it conventionally. The engine took several tries with the throttle on the transformer but eventually would run in forward with the speed being able to be controlled with the throttle. However it would not run in reverse. Again using the boost, it moved about a foot and after several tries, it took off uncontrolled until I shut down the throttle. It sounds like it needs a repair shop. My ambition here was to just identify if it was something I programed by mistake or does it need help from a service person. Again, any thoughts are appreciated. Bill
|
|
