Skip to main content

Reply to "TMCC Control With Arduino"

Thanks again for helping me with this project.  I'm a retired EE & SW engineer and wrote a lot of code back in the day, but mainly in assembler and FORTRAN (sigh).  Have done a fair amount of C but never migrated to C++.  But I found the C++ libraries for TMCC train control, just hope that I can figure out how to use them.  But I'm retired now and since my wife is gone I have plenty of time to run the train room at my retirement community, especially the electrical part.  So I'm fully dedicated to the journey as well as the goal.  Now can I toot the whistle on my N&W 611 engine from my Arduino in under 100 days?  Then I must interface to an RFID reader and a small LCD display to complete my project.  Let the fun begin! [Should I put the first curly brace on a separate line or on the same line with the function call? (-: ] 

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×