Skip to main content

Reply to "TMCC Engine found but wont run under DCS"

I set the address for the engine at #1 with the TMCC remote. I then programmed the DCS remote as instructed but still not operating. I also came across another problem, I did the install yesterday and a 30 minute test run. It seemed everything function well but today I put power to the track and the locomotive took off down the rails. After putting power to the track several times it began to function normally but the last run it shot down the track again. Could it be a bad program run switch? It worked great yesterday but I do not know what happened.

Last edited by RRAddict

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×