gunrunnerjohn posted:Until you get the correct power supply, you can run a wire from pin 5 of the serial connector to earth ground (3rd prong of grounded outlet) and get the same effect.
Well I took the base 1 apart and found pin 5 like you said soldered a wire and drilled a hole in the cover and put it back together, then I found a old computer power supply cord and cut it apart took the green wire and hooked the two together hooked up the u to ground side of my track and then power up everything at this point all is well. Powered up my tablet found my speeder then went to 2 on speed then it started to move I had control of the speeder all around the layout over 150 feet round trip GUNRUNNERJOHN U DA MAN
one more question is the base1 better that the base1L with DCS I do not have any of the cabs
Thanks to all for your response
This forum is the best
Henry