MartyE posted:c6usa posted:gunrunnerjohn posted:Until you get the correct power supply, you can run a wire from pin 5 of the serial connector to earth ground (3rd prong of grounded outlet) and get the same effect.
Well I took the base 1 apart and found pin 5 like you said soldered a wire and drilled a hole in the cover and put it back together
Henry
Why would you open up the base and drill a hole when pin 5 is available on the 9 pin connector? I mean it's your base but seems a lot of work to pull pin 5 from inside vs the serial connection.
I am using the 9 pin to go to my DCS TIU and it was easier to open the case and solder a wire to the backside of the pin than open the cable, over all it took less than 5 minutes to do this.