Skip to main content

TMCC/Legacy signal not responding

So I finally got the wiring done on my layout and got all the command systems set up (Cab-1, Cab-2, and DCS). I have two 135 bricks hooked up to a TPC300 and that works completely fine, I can control the TPC without issue and such, same thing with the DCS system as I had no issues running that. However when I put, currently two TMCC units (one Atlas and one Lionel) on I get no signal or just a signal blip if I'm lucky, such as the horn going for about one second even when I'm holding the slider down if the units start up. I ruled out that it's the units themselves.

Currently the legacy base is under the layout and I even pulled it out from under the layout to get a better signal but still got nothing. This has me really stumped.Diagram

Here is the diagram of the set up I have currently

Attachments

Images (1)
  • Diagram
Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×