Guys, I'm not going to leave the remaining folks totally out in the cold. I still have a quantity of parts for the thru-hole version from when I was going to hand build them. That was before the quantities skyrocketed out of control and I realized that I could never build that many by hand in any reasonable time! When I went to surface mount, I had to also start over with most of the components for obvious reasons.
My plan, after I get through this crush of shipping all of these, is to offer a kit of parts, including the PCB and parts. It will have the same functionality as the assembled version, and obviously will cost less since you get to do a lot of the work. We'll discuss the exact options once I get done with this run. One of the issues are whether to offer the enclosure that has been prepped for the board, etc. I mention this as I already have a drilling technique and the tools to cut the slots. Since the little boxes are a few bucks, it's best not to have to use three or four getting all the holes and slots in the right place.
I will start a separate thread for the kit version, we can sort out the details of the offering at that time.