Skip to main content

Reply to "TMCC/Legacy Track Signal Booster (Dale's Legacy Continues)"

Not at all Bill.  When you connect the BASE1 to the Legacy base, that enables the CAB1 to send commands over to the Legacy base and out to the track.  The buffer doesn't change any of that wiring, just leave it as is.

  1. The only thing you do to install the buffer is remove the wire to the track from the Legacy base and connect track to the buffered output. 
  2. Connect the legacy base track output to the buffer input.
  3. Finally, install the tether and connect the loose wire to the Earth GND on the buffer.

The buffer is installed ready to do, plug it in and away you go.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×