I'm soldering the track pieces together because most of my Fastrack is probably 10-12 years old, my old layout had to be torn down for me to have a hospital bed for awhile, and it was stored in my garage almost 6 years. I cleaned it up the best I could, tossed quite a few pieces that had rusted too much to save, so I'm obviously concerned about Electrical Conductivity through the rail joints, that's why I'm doing feeders every 6 pieces of track and jumper wires both hot and common between each piece of track in that six piece section. It's a lot of soldering but I want to take the time to hopefully reduce chances of issues once I get it together. It's been a challenging project from the start but I'm too stubborn to not keep going!😂
|
|
