Skip to main content

Reply to "Toggle switches and LED's for control panel"

@VinceL posted:


Given I will be running DCS and Legacy, will running the center rail power through one pole of the toggle switch and 120VAC to the LED's on the other pole lead to any interference of the DCS signal (not worried about Legacy since it uses the ground)?

Vince,

There shouldn't be a DCS issue but there would be a hazard to people.

Mixing switched line voltage and low voltage within the same vicinity, without adequate physical separation or a barrier, is not a good idea.  An accidental short circuit between adjacent terminals in your switch wiring would place a potentially lethal line voltage (120 VAC) on the track.

There's no doubt that you'd not plan on doing that intentionally, but unintentional things do occasionally happen.

Mike

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×