Carl, ( Moonman )
I know it is hard to believe but we have never had a problem with the crossover until my Dad bought the MTH 911 engine. He has 1 other MTH engine and it worked fine....
Now to the powermasters... In the other forum under TMCC i posted the same question and was give a few suggestions. I also have the manual for the powermaster and tried to reset them to the factory setting. I've looked at the troubleshooting section and tried there suggestion also but they are still not working... Both were working fine until the crossover problem started.
When powered the green light comes on and acting like it is ready. The switches are in the run and con mode. When the red knob is turned the Red light then blinks but it is different on both sides. I will say side A and B.
Side A ----- When track power is turned on by a toggle switch it is on full power even tho the powermaster should be no power until the red knob is turned.
Side B---- When track power is turned on to the track is getting little power and will not turn off all the way. Also if you put a engine on the track it will only go backwards and you can not sound the horn or bell.
Again they were both working before the crossover problem.... Hope you can help me with this as we really want to use the Cab 1 for operational .
Have a great night,
David
