If, I had the entire basement - I could do that. For orientation. The RR-Track Print needs to be the lower right, the R&S Enterprises it top right. KM4.rrt upper left and the date the lower left. So the space I have to operate is approx 26 by 20.
Solid wall on the right. Currently about 2 Ft. from the right wall to the edge of the table. Then across the top is 2 ft as well. On the left is a man-made wall, built by me with an opening. Between the wall and the mechanical room is a door to the outside.
The lower left is the mechanical room, Water heater, boiler, electrical panel and tool storage. On the lower right, the gap between the 3.0. mark to the 11.0 mark is a hallway / opening to the other side of the basement where the laundry room, full bath and my office is located.
Bottom line - trying to fit as much as possible into the 20*26 foot area. What I left out is where I put a control panel which means, other than the index system, I might need to use DCS or Legacy to control witches much like Rich Battista did on the Black Diamond RR.
