ADCX Rob, thank you very much for the help.
Let me make sure I understand this.
I am running on a 4'x8' sheet of plywood with an oval. At the moment, A is my middle Rail, Lockon 1. U is the inside rail of the oval. Lockon 2.
What I need to do.
Change A to my outside rail of the oval.
Change U to the middle rail.
Now I can run a single power wire from A to the switch for 5 volts, or
B to the switch for 11 volts, or
C to the switch for 16 volts.
Does this mean that U functions as a ground wire?
Did I get it?
My only other question is can I convert my controller on my remote control set type UCS to DPDT momentary switches with a center rest. Is that possible?