Skip to main content

Trying to run 1996 MTH Protosounds engine with Lionel Legacy Command base & ZW-l

As noted in the subject, I am trying to run my 1996 MTH BL2 Protosounds engine (FEC) with a Lionel Legacy Command base & ZW-L in command mode.  The sound comes up with a lot of static and the engine doesn't seem to run smoothly (starts, stops, starts again).  Do I need some sort of MTH controller instead or some sort of electrical filter or is this just not possible to do this.  I was hoping to actually run my old Protosounds (QSI) engines on the new layout.

I only have three of these early engines.  Would I be better off just selling them?  I haven't really used them since purchasing them in the late 1990's because trying to run them on a layout and controlling them with the Clinks & Clanks (remember those!) was just idiotic.

Any help, directions, or advice is greatly appreciated.

LionelFlyer

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×