Skip to main content

Reply to "Uncoupler locations & hidden/undertable uncouplers"

Originally Posted by sinclair:

So, that both after the switch, not in front of the switch?  Front being the single end of the switch and after being on the two diverging ends?  I figured that would be the locations, but due to the problem I had of locomotives stalling out on them being so close to the switch I'm leery of it.  But I was using O36 switches before, and will use O72 on my layout.

Correct. One on each of the diverging ends, but you can place them further back if you're concerned about the engine stalling...

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×