Reply to "Using a generic toggle switch with a Lionel Fastrack remote switch"

Thanks for your replies. So if I’m reading this right, the red and green wires attach to the outer posts of the momentary switch, the black wire attaches to the center post of the momentary switch, and the yellow wire only attaches to the bi-color LED with a resistor. I’m assuming the resistor goes on the anode (long) leg of the LED and then to the yellow wire, and the chathode (short) leg gets attached to the center post with the black wire. With or without a resistor? Is that correct? Thanks for your patience in walking me thru this.