Skip to main content

Reply to "Using Lionel TMCC"

In addition to the above tips, make sure the Challenger ODY, No ODY (Odyssey, No Odyssey) is in the ODY position. I was having problems with mine stopping for no apparent reason on curves, until I discovered that I had it on No ODY.

 

I have a first issue U-boat, and continue to have problems (see my earlier post and Carl T's response) because the wheels are not sprung. I'm using Gilbert sectional track, and any irregularity will cause it to stall, or stop momentarily, then go again. A slight unevenness in rail height from one section to the next, a slight dip in one rail, and a transition from level to incline, or vise versa, will cause it to stop; also dirty track or wheels. I've found that running it a little faster than I probably would otherwise is usually enough to carry it through the "bad" spots.

 

I run both loco's with a CAB 1.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×