I don't think so, that is why I pointed out the offset.
If you look at the thin green line I drew, in the copy of your clip, that is near an 1/2" off.
It needs to be closer, even at 30" that is too much offset for only two connections (without flex).
In real life separate pieces for the 30" span would split that same track to track connection angle, among 4 connections, lessening the severity at each joint, and increasing the chances for it to work out.
Evening the corner out by replacing tracks associated the green arrow leg to get that green line offset down under an 1/8" is what I was getting at.
Or, if you can, remove the piece from under the green arrow. Move the curve as a section till it aligns better with both straights. Then try to fill both the gaps.
