Skip to main content

Using TIU as control only...not power distribution

I plan on running a large loop...using a lionel tpc 300 with two 135 watt bricks to keep the wattage/voltage up over this long run.

I'm using this power setup for more power plus the added circuit breaker protection built in.

I will be running both DCS and Legacy/TMCC engines.

Can the MTH tiu be connected in the same manner as the legacy command base...as a control unit and not a power control...while power is applied to the track through a separate source?

If so...how should it be connected to the powered track?

Last edited by gibson man
Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×