Skip to main content

Reply to "Voltage Drop In Section Of Flextrac"

Gentlemen, thanks again for all the responses.  Regarding not knowing the cause of the problem, I guess the best assumption I can make is that the drop in voltage was caused by the single track pin that was in about 1/3 further than normal.  I can't determine any other reason. The situation was remedied once the track was replaced, without putting any additional power to the track in or around the troubled location.

Bottom line, it's clear sailing...and I'll add power this afternoon to the curved track area mentioned above

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×