@stan2004 posted:
Nice. I would NEVER have found it!. The lack of readily identifiable manufacturer part numbers makes this a challenge of course.
So as to understand one of your previous comments, it seems that if the connector is only held down on one side that you can't easily open a lever with one hand without having the connector pop out of the clip? In other words this is more of a retention clip to keep things neat after the wiring is done. I can see how it would work if 2 sides are held down like the example in the middle. Not sure I'm being clear...
The single clip with the bus type (snaps/levers only on one side), the connector kept coming off the orange holder/mount. I had to superglue the connector to the mount. Now whenever I mount one it stays in place and am able to connect wires, without the connector popping off the mount.
The side mounts are only for the pass through connectors (the ones with snaps/levers on both sides).
I prefer these for pass through connections. they are already mountable. Plus they have the test ports also.
