Skip to main content

Reply to "Weak DCS signals, Failed TIU Output Drivers, and Design Solutions devloped under collaboration between AGHR and MTH"

My problem is that I don't have the platform for "months of testing" right now, so it's all theoretical for me right now.   I was hoping someone would have the venue that could give it a proper run and see if it's a real solution.  I put them on a TIU by just sticking the bottom to the 244 chip and then running the wires to the pads.  I found the easiest way was to solder the leads to the 244 chip sticking up, then mount the protection board, and finally tack the leads to the protection board pads.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×