Skip to main content

Reply to "Weaver GS2 Trainmaster help"

You can convert this engine to TMCC or DCS. Either way, you have to completely gut the existing electronics package from the engine. If you go with TMCC, you will have to electrically insulate the tender shell from the frame, or insulate a handrail on the boiler. Otherwise the TMCC signal will never get to the board.

Actually, once you get the hang of it, PS1 is not all that complicated. And the QSI boards you have are pretty robust. Unless you are married to the command control idea, you may want to learn about using all the clicks and clanks. BTW, when you first start  the engine, do not go above 10v. Instead, lower the throttle, then advance it again. That will put you in neutral. After that you can raise and lower the throttle as you desire and the engine will cycle between neutral, forward, neutral, reverse, etc. Going above 10v when you first start puts you in Reset, where you get all the clinks and clanks to program the engine.

 

Chris

LVHR

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×