chris a posted:Finally updated the firmware/software in my Legacy Base and 2 CAB2's to the V1.6 that I purchased during the recent Lionel parts sale in November. Second controller seems to be playing nice and operating without the glitches...
Had to remove and replace my engine service "departure track" as the spacing wasn't correct for the new to me GGD Ogle Coaling tower. Ended up removing a LH Ross Regular switch and replacing it with a cut down Ross 096 LH switch to get the track spacing right. Ironically the 096 is a much smoother transition than the Ross regular which is pretty abrubt at the points. Then I bent 2 full Gargraves sections to make smooth transitional curves from the turnout to the turntable. Made some "concrete foundation piers" for the Ogle Coaling tower legs to sit and finished weathering them this afternoon.
While I was there I took a couple of photos from places I don't normally get to with the camera and tripod. Figured it was best not to fill up the whole page with photos, so most are attached below.
Chris,
Some great work here! The scenes and your angles are bringing the best out of your layout. Thanks for sharing.
Dave
