Oh,,today,,,,,,,,,,,,,,,
Today was one of those John Entwistle "Smash Your Head Against the Wall" days. All looked fine on the floor and I started to lay it out on the table. Everything was working way to good. Then I tried to add the loop to the north end west side and it hits the outer elevated loop so it needs to be cut back about 8". Problem is the straight sections are not parallel so all of the geometry is all messed up. Guess I have to take what I got and try to save what I can. So much for the SCARM program .
BUT!!!
After looking back over a beer of desperation,,,,,, I had to go back to the original way I drafted it and now it is just like in the SCARM drawing. Stupid me, I threw a curve in that was not in the program that threw it all off.
Heck if it was easy everyone would do it.
The plan is to get it all up and running then take it off and finish it, then re-install it to the table.
Now,,,to start on the south reverse loop. 
