Skip to main content

Reply to "WHAT’S ON THE WORKBENCH AT THE MOMENT"

Bill, I'm pretty sure yours has an LCRU in it, the original TMCC board. The newer version LCRU2 has a 6 pin molex connector on the end of the board with the heat sinks, just to make the distinction. The wires to your motor, pickup rollers and ground are all hard-wired to the board. The Front/Rear couplers, the headlight, strobe, and the prog/run switch all connect to the pins as shown below

LCRU1_wiring_w_pin_names_DIESEL

I think you said yours had a strobe, so it would be this one:

LCRU1_wiring_w_pin_names_DIESEL_W-MARS

George

Attachments

Images (2)
  • LCRU1_wiring_w_pin_names_DIESEL
  • LCRU1_wiring_w_pin_names_DIESEL_W-MARS

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×